Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
panel [2018/12/20 06:58]
66.232.203.23 [MKS TFT32 3.2-inch Full-Color Touch Screen]
panel [2019/03/06 17:58]
wolfmanjm old revision restored (2019/03/02 01:25)
Line 162: Line 162:
  
 On the back of the GLCD EXP1 is to left and EXP2 is to right, pin 1 is bottom left, pin 2 is top left etc. On the back of the GLCD EXP1 is to left and EXP2 is to right, pin 1 is bottom left, pin 2 is top left etc.
-=5v is EXP1 pin 10, Gnd is EXP1 pin 9+5v is EXP1 pin 10, Gnd is EXP1 pin 9
  
 <​code>​ <​code>​
Line 387: Line 387:
 panel.external_sd.sdcd_pin ​         0.28!^ ​          # sd detect signal (set to nc if no sdcard detect) panel.external_sd.sdcd_pin ​         0.28!^ ​          # sd detect signal (set to nc if no sdcard detect)
 </​code>​ </​code>​
- 
-== MKS TFT32 3.2-inch Full-Color Touch Screen ​ 
- 
-The MKS TFT32 3.2-inch Full-Color Touch Screen is a full screen LCD touch screen controller for the MKS SBASE 1.3. 
- 
-Image: https://​tinyurl.com/​y8rxyx5o 
- 
-The touch screen makes navigation fast and the full color is helpful to those with vision problems. 
- 
-<callout type="​info"​ icon="​true"​ title="​ Power and Data">​ 
-Power and data is via a flat cable connected to the AUX-1 connection on the Smoothieboard. ​ 
-</​callout>​ 
- 
-<callout type="​info"​ icon="​true"​ title="​ Firmware">​ 
-This display has firmware which can be flashed using the same steps as flashing the MKS SBASE 1.3 except using an mkstft28.bin file. 
- 
-When flashing the display firmware you must use the SD card reader built into the display. ​ The microSD on the MKS SBASE 1.3 will not work for flashing the display firmware. 
-</​callout>​ 
- 
-<callout type="​info"​ icon="​true"​ title="​ Customization">​ 
-Look and functionality of this display can be altered by updating the configuration file in the same manner as the MKS SBASE 1.3 except using an mks_config.txt file. 
- 
-When updating the display configuration you must use the SD card reader built into the display. ​ The microSD on the MKS SBASE 1.3 will not work for updating the display configuration. 
- 
-The touch screen controls will not function properly if the display baud rate does not match the board baud rate: 
- 
-Sample configuration entry: 
- 
-#baud rate (9600:1; 57600:2; 115200:3; 250000:4) 
->​cfg_baud_rate:​4 
- 
-</​callout>​