This is an old revision of the document!

laser_module_enable true Whether to activate the laser module at all. All configuration is ignored if false. The laser module is used for laser cutting using a laser diode or CO2 laser tube.
laser_module_pwm_pin 2.5 This pin will control the laser. Pulse width will be modulated to vary power output ( PWM ). Note : PWM is available only on pins 2.0 to 2.5, 1.18, 1.20, 1.21, 1.23, 1.24, 1.26, 3.25 and 3.26
laser_module_ttl_pin 1.30 This pin turns on when the laser turns on, and off when the laser turns off.
laser_module_maximum_power 0.8 This is the maximum duty cycle that will be applied to the laser. Value is from 0 to 1
laser_module_minimum_power 0.0 This duty cycle will be used for travel moves to keep the laser active without actually burning. Useful for some diode setups. Value is from 0 to 1
laser_module_pwm_period 20 PWM frequency expressed as the period in microseconds