Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
zprobe [2020/04/19 19:10]
wolfmanjm [Example configuration]
zprobe [2020/04/19 22:16] (current)
wolfmanjm [Example configuration]
Line 177: Line 177:
 leveling-strategy.delta-calibration.initial_height ​       10        # The initial height above the bed we stop the initial move down after home  leveling-strategy.delta-calibration.initial_height ​       10        # The initial height above the bed we stop the initial move down after home 
                                                                     # to find the bed. This should be a height that is enough that the probe                                                                     # to find the bed. This should be a height that is enough that the probe
-                                                                    # will not hit the bed and is an offset from zprobe.max_z (can be  +                                                                    # will not hit the bed
-                                                                    # set to 0 if zprobe.max_z takes into account the probe offset)+
 </​code>​ </​code>​