The following table lists the configuration options for the Z-probe module:
| Option | Value | Description |
|---|---|---|
zprobe.enable |
true |
Set to true to enable the Z-probe module. This is used to scan surfaces, and to calibrate parameters and compensate for non-planar surfaces. |
zprobe.probe_pin |
1.28!^ |
Pin the probe is connected to. |
zprobe.slow_feedrate |
5 |
Speed in millimetres/second at which the probe seeks a surface. |
zprobe.fast_feedrate |
100 |
Speed in millimetres/second at which the probe does fast moves. |
zprobe.return_feedrate |
50 |
Speed in millimetres/second at which the probe does the return after a probe. |
zprobe.debounce_ms |
1 |
Debounce the probe pin over this number of milliseconds. Set to 1 or 2 if your probe is too noisy and gives false readings. |
zprobe.probe_height |
5 |
Distance above the bed at which the probing is started, once the bed’s height is known. |
zprobe.max_z |
200 |
Maximum Z (was gamma_max) |
zprobe.dwell_before_probing |
0.2 |
Dwell time in seconds before probing. Useful for piezo Z-probe to avoid false trigger. |