Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
supported-g-codes [2020/11/12 23:17] wolfmanjm |
supported-g-codes [2021/02/22 17:59] (current) |
||
---|---|---|---|
Line 38: | Line 38: | ||
| G31 | Depends on levelling strategy selected, see [[ZProbe]] | | G31 | Depends on levelling strategy selected, see [[ZProbe]] | ||
| G32 | Depends on levelling strategy selected, see [[ZProbe]]. For calibration on delta, uses Z probe to calibrate delta endstops and arm radius, use R parameter to select only arm radius calibration and E to select only endstop calibration. I to set target precision, J to set probe_radius, | | G32 | Depends on levelling strategy selected, see [[ZProbe]]. For calibration on delta, uses Z probe to calibrate delta endstops and arm radius, use R parameter to select only arm radius calibration and E to select only endstop calibration. I to set target precision, J to set probe_radius, | ||
- | | G38.2 G38.3 | Standard probe commands implemented as documented [[http:// | + | | G38.2 G38.3 G38.4 G38.5 | Standard probe commands implemented as documented [[http:// |
| G43.2 | [[http:// | | G43.2 | [[http:// | ||
| G53 | Must be on a line by itself OR the first G code on a line, the directly following G0/G1 will be executed in MCS coordinates | < | | G53 | Must be on a line by itself OR the first G code on a line, the directly following G0/G1 will be executed in MCS coordinates | < |