Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
pcb-milling [2019/03/07 22:30]
wolfmanjm [Usage]
pcb-milling [2019/03/07 22:33] (current)
wolfmanjm [PCB milling]
Line 12: Line 12:
  
 **Note** that all positions for probing are in the MCS ( machine coordinate system ) and not in the WCS ( work coordinate system ). **Note** that all positions for probing are in the MCS ( machine coordinate system ) and not in the WCS ( work coordinate system ).
 +
 +In the latest version there is a quick way to use two corners mode without setting it in config...
 +''​G32 R1 X0 Y0 A30 B30''​
 +The R1 sets a special two corners mode which uses the current position as the start x and y, the X and Y specified in the G32 will be offsets from that and would usually be specified as 0
  
 === Usage === Usage