Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
guide-endstops [2017/05/05 00:06]
199.66.67.63 grammar
guide-endstops [2019/05/06 11:34]
195.184.180.134 [Powered endstops wiring] changed endstop M119 trigger/not triggered text
Line 18: Line 18:
 However, end-stops are not necessary, you could do without them. They are just so convenient that most machines use them. However, end-stops are not necessary, you could do without them. They are just so convenient that most machines use them.
  
-End-stops can also be used as Limit Switches ​which prevent the machine from attempting to move beyond the physical limits of the axis (by pausing/​stopping movement when triggered), see the [[http://​smoothieware.org/​endstops|Endstops page]] for details about configuring Smoothie to use End Stops as limit switches.+End-stops can also be used as limit switches ​which prevent the machine from attempting to move beyond the physical limits of the axis (by pausing/​stopping movement when triggered), see the [[http://​smoothieware.org/​endstops|Endstops page]] for details about configuring Smoothie to use End Stops as limit switches.
  
 <callout type="​warning"​ icon="​true"​ title="​ Note">​ <callout type="​warning"​ icon="​true"​ title="​ Note">​
  
-Smoothie does not allow you to use a zprobe as an endstop. An endstops ​must be dedicated to being an endstop and cannot be used as a zprobe and vice versa.+Smoothie does not allow you to use a zprobe as an endstop. An endstop ​must be dedicated to being an endstop and cannot be used as a zprobe and vice versa.
  
 </​callout>​ </​callout>​
Line 110: Line 110:
 To know exactly what your endstop does, see it's documentation. To know exactly what your endstop does, see it's documentation.
  
-If once wired, your endstop reports the opposite of what it should via the <​kbd>​M119</​kbd>​ command ( <​kbd>​1</​kbd>​ when not triggered, and <​kbd>​0</​kbd>​ when triggered ), see the "​Testing"​ section.+If once wired, your endstop reports the opposite of what it should via the <​kbd>​M119</​kbd>​ command ( <​kbd>​1</​kbd>​ when triggered/pushed, and <​kbd>​0</​kbd>​ when not triggered ), see the "​Testing"​ section.
  
-Some endstops might require removing their "​pull-up"​ configuration,​ in this case, change : +Some endstops might require removing their "​pull-up"​ configuration,​ in this case, change :
  
 <​code>​ <​code>​
Line 130: Line 130:
 </​code>​ </​code>​
  
-In some very rare cases, the endstop reading circuit on the [[Smoothieboard]] will not be adequate for your endstop type. In this case, you should use a "​free" ​GPIO pin ​on the Smoothieboard that nothing else uses to connect your endstop to.+In some very rare cases, the endstop reading circuit on the [[Smoothieboard]] will not be adequate for your endstop type. In this case, you should use a "​free" ​GPIO pin ​on the Smoothieboard that nothing else uses to connect your endstop to.
  
 See [[Pinout]] to find adequate pins. See [[Pinout]] to find adequate pins.