Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
grbl-mode [2017/12/18 12:49]
146.90.249.33
grbl-mode [2018/05/24 13:55] (current)
146.90.249.51
Line 65: Line 65:
 2. G28 goes to park position and is NOT home, $H homes in CNC mode 2. G28 goes to park position and is NOT home, $H homes in CNC mode
 3. Many GCodes may be differently interpreted in CNC mode than in 3D mode, please check your gcode references (Linuxcnc has a good GCode reference, do not use the reprap gcode reference for CNC mode) 3. Many GCodes may be differently interpreted in CNC mode than in 3D mode, please check your gcode references (Linuxcnc has a good GCode reference, do not use the reprap gcode reference for CNC mode)
 +
 +**NOTE** you cannot generally use pronterface to control CNC/grbl mode, as Pronterface is for 3D printers and uses a different dialect of gcode, it also does not allow you to send commands such as $H to home. It also tends to truncate commands like G28.2 by not sending the .2 part.
 +