Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
drillingcycles [2017/01/25 18:37]
arthur
drillingcycles [2017/04/21 18:05]
67.140.70.105 Just spelling correction
Line 1: Line 1:
 = Drilling cycles module = Drilling cycles module
 Basically the canned drilling cycles is a short G-Code produced by some serious CAM software to make holes. Basically the canned drilling cycles is a short G-Code produced by some serious CAM software to make holes.
-In addition to adding some features this significantly reduces the number of instructions ​send through the serial port.+In addition to adding some features this significantly reduces the number of instructions ​sent through the serial port.
  
 Currently the drilling cycles module implement the first three options in absolute mode <​kbd>​G90</​kbd>​ only. Currently the drilling cycles module implement the first three options in absolute mode <​kbd>​G90</​kbd>​ only.
Line 14: Line 14:
  
 = Configuration = Configuration
-||~ Option ​||~ Example value ||~ Explanation ​||+Option ​Example value Explanation ​^
 {{page>​drillingcycles-options}} {{page>​drillingcycles-options}}