Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
delta-grid-calibration-options [2017/02/08 04:29]
99.139.75.113
delta-grid-calibration-options [2017/02/16 22:25]
wolfmanjm
Line 1: Line 1:
 || leveling-strategy.delta-grid.enable ​ ||  true   || The strategy must be enabled in the config, as well as the zprobe module. || || leveling-strategy.delta-grid.enable ​ ||  true   || The strategy must be enabled in the config, as well as the zprobe module. ||
-|| leveling-strategy.delta-grid.is_square|| ​ true  ||  must be set to indicate this is a cartesian square bed || 
-|| leveling-strategy.delta-grid.max_x ​  ​|| ​ 50     ​|| ​ the distance from center of bed to the right edge || 
-|| leveling-strategy.delta-grid.max_y ​  ​|| ​ 60     ​|| ​ the distance from center of bed to the bottom edge || 
 || leveling-strategy.delta-grid.size ​   ||  7      || The size of the grid, for example, 7 causes a 7x7 grid with 49 points. Must be an odd number. || || leveling-strategy.delta-grid.size ​   ||  7      || The size of the grid, for example, 7 causes a 7x7 grid with 49 points. Must be an odd number. ||
-|| leveling-strategy.delta-grid.probe_offsets || 0,0,0  || Optional probe offsets from the nozzle or tool head ||+|| leveling-strategy.delta-grid.probe_offsets || 0,0,0  || Optional probe offsets from the nozzle or tool head **NOTE Z must be 0** ||
 || leveling-strategy.delta-grid.save ​   || false   ​|| ​ If the saved grid is to be loaded on boot then this must be set to true || || leveling-strategy.delta-grid.save ​   || false   ​|| ​ If the saved grid is to be loaded on boot then this must be set to true ||
 || leveling-strategy.delta-grid.initial_height || 10 || Optionally an initial_height can be set that tell the initial probe where to stop the fast decent before it probes, this should be around 5-10mm above the bed || || leveling-strategy.delta-grid.initial_height || 10 || Optionally an initial_height can be set that tell the initial probe where to stop the fast decent before it probes, this should be around 5-10mm above the bed ||