Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
stopping-smoothie [2018/06/26 15:14]
143.159.81.111 		stopping-smoothie [2021/02/22 16:59] (current)
Line 8: Line 8:
 | No command, but there is a configurable «kill» button | <kbd>M112</kbd> | Stops instantly if kill button pressed, if issued from host has to wait for the receive buffer to have room. | Turned off | aborted | No, position is lost, home will be required | [[supported-g-codes]] | Instantly stops all operations, printer fully halts until <kbd>M999</kbd> is sent. Position is lost. | | No command, but there is a configurable «kill» button | <kbd>M112</kbd> | Stops instantly if kill button pressed, if issued from host has to wait for the receive buffer to have room. | Turned off | aborted | No, position is lost, home will be required | [[supported-g-codes]] | Instantly stops all operations, printer fully halts until <kbd>M999</kbd> is sent. Position is lost. |
 | Sending Control-X to smoothie over the serial port or USB serial port | | should work at any time even when streaming, does the same as the kill button | Turned off | aborted | No, position is lost, home will be required | | Instantly stops all operations, printer fully halts until <kbd>M999</kbd> is sent (or $X). Position is lost. | | Sending Control-X to smoothie over the serial port or USB serial port | | should work at any time even when streaming, does the same as the kill button | Turned off | aborted | No, position is lost, home will be required | | Instantly stops all operations, printer fully halts until <kbd>M999</kbd> is sent (or $X). Position is lost. |
-| Sending ! (feed hold) or ~ (Continue) | | should work at any time even when streaming| Not affected | Paused | Yes | |Causes feed hold state after current queue is finished, resume with ~ | 
  
  
Line 14: Line 13:
  
 All commands can be triggered by a button or a sensor if a [[Switch]] module is configured to do so. All commands can be triggered by a button or a sensor if a [[Switch]] module is configured to do so.
 +
 +You can read more about the kill button at [[killbutton|Smoothie kill button]]
  
 </callout> </callout>