Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
zprobe [2020/02/29 22:42]
arthur
zprobe [2020/03/04 14:27] (current)
wolfmanjm [Probing with Smoothie]
Line 20: Line 20:
 * For [[Delta]] machines, you can do [[#​delta-grid|grid leveling]] **and** [[#​delta-calibration|calibration]] * For [[Delta]] machines, you can do [[#​delta-grid|grid leveling]] **and** [[#​delta-calibration|calibration]]
 * For [[Cartesian]] machines, you can do [[#​rectangular-grid-compensation|grid leveling]] **or** [[#​three-point|three point leveling]] * For [[Cartesian]] machines, you can do [[#​rectangular-grid-compensation|grid leveling]] **or** [[#​three-point|three point leveling]]
 +
 +**NOTE** When G30 stores the probe position or prints out the value, it is in actuator units not necessarily in mm. This is only an issue for rotary deltas where the actuator units are degrees not mm. Most other configurations it will be mm.
  
 <​html>​ <​html>​