Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
zprobe [2019/04/18 18:36]
wolfmanjm [Configuration]
zprobe [2019/04/18 18:37]
wolfmanjm [Rectangular Grid Compensation]
Line 572: Line 572:
 **NOTE** there is **NO** extrapolation in this version, However the very latest firmware will not jump when outside the probed area, it will just use the nearest edge heights instead. **NOTE** there is **NO** extrapolation in this version, However the very latest firmware will not jump when outside the probed area, it will just use the nearest edge heights instead.
  
-**NOTE** you **MUST** set Z0 correctly (or close) before issuing the G32 probe as it will move to the specified ''​initial_height''​ before it starts to probe so it needs to know where Z0 is approximately.+**NOTE** you **MUST** set Z0 correctly (or close) before issuing the G32 probe as it may move to the specified ''​initial_height'' ​(if set) before it starts to probe so it needs to know where Z0 is approximately.
  
 === Configuration === Configuration