Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
zprobe [2019/04/15 23:10]
wolfmanjm [Configuration]
zprobe [2019/04/18 18:36]
wolfmanjm [Configuration]
Line 663: Line 663:
 </​callout>​ </​callout>​
  
-An initial_height ​must be set that tells the probe where to start the first probe from, this should be around 5-10mm above the bed, it will move to the absolute Z position specified here.+An initial_height ​**may** ​be set that tells the probe where to start the first probe from, this should be around 5-10mm ​above the probe height ​above the bed, it will move to the absolute Z position specified here before it starts the first probe. Fir instance this is useful for bltouch probes that are deployed automatically as it will lift the probe off the bed before moving to the first probe position.
        
 <​code>​ <​code>​