Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
zprobe-options [2018/03/08 18:12]
88.162.4.146 adding dwell setting
zprobe-options [2019/05/12 11:41] (current)
139.47.118.163
Line 1: Line 1:
-|| zprobe.enable || false || Set to true to enable the Z-probe module. This is used to scan surfaces, and to calibrate parameters and compensate for non-planar surfaces. || +|| zprobe.enable || true || Set to true to enable the Z-probe module. This is used to scan surfaces, and to calibrate parameters and compensate for non-planar surfaces. || 
 || zprobe.probe_pin || <​kbd>​1.28!^</​kbd>​ || Pin the probe is connected to. ||  || zprobe.probe_pin || <​kbd>​1.28!^</​kbd>​ || Pin the probe is connected to. || 
 || zprobe.slow_feedrate || 5 || Speed in millimetres/​second at which the probe seeks a surface. ||  || zprobe.slow_feedrate || 5 || Speed in millimetres/​second at which the probe seeks a surface. || 
Line 7: Line 7:
 || zprobe.probe_height || 5 || Distance above the bed at which the probing is started, once the bed's height is known. || || zprobe.probe_height || 5 || Distance above the bed at which the probing is started, once the bed's height is known. ||
 || zprobe.max_z ​ || 200 || Maximum Z (was gamma_max) || || zprobe.max_z ​ || 200 || Maximum Z (was gamma_max) ||
-|| zprobe.dwell_before_probing || 0.2 || Dwell time in seconds before probing. (usefull ​for piezo Z-probe)+|| zprobe.dwell_before_probing || 0.2 || Dwell time in seconds before probing ​|| Usefull ​for piezo Z-probe ​to avoid false trigger