Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
troubleshooting [2019/05/12 21:55]
arthur [How to troubleshoot]
troubleshooting [2019/07/20 11:37] (current)
arthur [What is wrong with MKS ?]
Line 102: Line 102:
  
 When posting on a forum/​social media to get help, attach your config ( it's pastebin link ), but also these pictures, as well as a description of your machine/​setup ( as detailled as you can be patient for, with special time taken for anything that is not commonly done/​unusual ). When posting on a forum/​social media to get help, attach your config ( it's pastebin link ), but also these pictures, as well as a description of your machine/​setup ( as detailled as you can be patient for, with special time taken for anything that is not commonly done/​unusual ).
 +
 +If using a mailing list, do not insert the pictures in the body of your email, but rather attach them to the email. This make things easier for volunteers helping you, and not doing so often leads to ridiculously weird email client layouts ( for example if the picture is much larger than the screen ).
  
 ==== 7. Before asking the community for help. ==== 7. Before asking the community for help.
Line 597: Line 599:
  
 Was: « Somebody refused to help me because my board is a MKS, what's that all about ? » Was: « Somebody refused to help me because my board is a MKS, what's that all about ? »
 +
 +Note : This was written at a time when only MKS was doing this, there are now also SKR boards,​ and even counterfeit Smoothieboards,​ all/most of this is valid for these too.
  
 Smoothie is a community-built Open-Source project. Many people around the world come together to work and share to make the best possible CNC controller. They put likely more than a century of cumulated work into this, and make a lot of sacrifices so that *you* can have the best controller board and firmware possible, with the best documentation and best support. Smoothie is a community-built Open-Source project. Many people around the world come together to work and share to make the best possible CNC controller. They put likely more than a century of cumulated work into this, and make a lot of sacrifices so that *you* can have the best controller board and firmware possible, with the best documentation and best support.