Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
troubleshooting [2019/05/04 16:33]
80.99.59.202 Added new part: [My stepper motor changes direction randomly]
troubleshooting [2019/07/20 11:37] (current)
arthur [What is wrong with MKS ?]
Line 95: Line 95:
 Finally, make sure you mention all those steps you have taken when asking the community for help, if you don't people will start telling you to do things you have already done. Finally, make sure you mention all those steps you have taken when asking the community for help, if you don't people will start telling you to do things you have already done.
  
-==== 6. Before asking the community for help.+==== 6. Describe/​Take a picture of your setup 
 + 
 +Take a picture of your Smoothieboard,​ a global view of it ( tip : pictures are much sharper and therefore useful, if neither the camera nor the subject are moving. Deposit your camera on a flat surface or fix it in some fasion. If you think pressing the button will make it move, remember you can use a 5-second countdown to take pictures. ) 
 + 
 +Also take pictures of the connectors, wiring, motors, and overall machine. A picture is worth a thousand words. 
 + 
 +When posting on a forum/​social media to get help, attach your config ( it's pastebin link ), but also these pictures, as well as a description of your machine/​setup ( as detailled as you can be patient for, with special time taken for anything that is not commonly done/​unusual ). 
 + 
 +If using a mailing list, do not insert the pictures in the body of your email, but rather attach them to the email. This make things easier for volunteers helping you, and not doing so often leads to ridiculously weird email client layouts ( for example if the picture is much larger than the screen ). 
 + 
 +==== 7. Before asking the community for help.
  
 If you have an Open-Source board like the Smoothieboard,​ a board from Panucatt, or one of the many designed by the community and that support the project, ignore this. If you have an Open-Source board like the Smoothieboard,​ a board from Panucatt, or one of the many designed by the community and that support the project, ignore this.
Line 589: Line 599:
  
 Was: « Somebody refused to help me because my board is a MKS, what's that all about ? » Was: « Somebody refused to help me because my board is a MKS, what's that all about ? »
 +
 +Note : This was written at a time when only MKS was doing this, there are now also SKR boards,​ and even counterfeit Smoothieboards,​ all/most of this is valid for these too.
  
 Smoothie is a community-built Open-Source project. Many people around the world come together to work and share to make the best possible CNC controller. They put likely more than a century of cumulated work into this, and make a lot of sacrifices so that *you* can have the best controller board and firmware possible, with the best documentation and best support. Smoothie is a community-built Open-Source project. Many people around the world come together to work and share to make the best possible CNC controller. They put likely more than a century of cumulated work into this, and make a lot of sacrifices so that *you* can have the best controller board and firmware possible, with the best documentation and best support.