Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
switch [2018/04/06 15:42]
arthur
switch [2019/02/18 18:04] (current)
wolfmanjm [Console command]
Line 307: Line 307:
              ; Z is now level relative to it's two endstops, and can be used normally as if it were a single axis.              ; Z is now level relative to it's two endstops, and can be used normally as if it were a single axis.
 </​code>​ </​code>​
 +
 +Note if both your endstops are wired in parralel, you'll need to retract off one endstop before you can use the next one. As long as you retract by the same length for each endstop you'll be fine.
  
 ==== Alternative wiring ==== Alternative wiring
Line 374: Line 376:
  
 === Console command === Console command
-The is an escape character for Pronterface to not filter the non g-code.+**NOTE** precede with only if you are using Pronterface to not filter the non g-code.
 <​code>​ <​code>​
-@switch vac1read+switch vac1read
 </​code>​ </​code>​
  
Line 383: Line 385:
 switch vac1read is 0 switch vac1read is 0
 </​code>​ </​code>​
 +
 +Alternatively (with the very latest build) you can send
 +<​code>​
 +$S psu fan
 +switch psu is 1
 +switch fan is 0
 +</​code>​
 +
 +