Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
supported-g-codes [2018/10/18 22:18]
88.186.78.124 [G codes] Typos
supported-g-codes [2018/11/16 20:49]
178.148.197.25 M375.1 - display the current grid
Line 31: Line 31:
 | G28.3 | Manual Homing - This allows you to set a home position manually without moving to limit switches | <​kbd>​G28.3</​kbd>​ | | G28.3 | Manual Homing - This allows you to set a home position manually without moving to limit switches | <​kbd>​G28.3</​kbd>​ |
 | G28.4 | Manual Homing based on actuator position- This allows you to set a home position manually based on actuator position (used for rotary delta) | <​kbd>​G28.4</​kbd>​ | | G28.4 | Manual Homing based on actuator position- This allows you to set a home position manually based on actuator position (used for rotary delta) | <​kbd>​G28.4</​kbd>​ |
-| G28.5 | c*Clears the homed flag for the specified axis, or all if not specifed | <​kbd>​G28.5</​kbd>​ <​kbd>​G28.5 Z0</​kbd>​ |+| G28.5 | Clears the homed flag for the specified axis, or all if not specifed | <​kbd>​G28.5</​kbd>​ <​kbd>​G28.5 Z0</​kbd>​ |
 | G28.6 | Shows the homing status of each axis | <​kbd>​G28.6</​kbd>​ | | G28.6 | Shows the homing status of each axis | <​kbd>​G28.6</​kbd>​ |
 | G29 | Probes the bed and outputs the bed heights depending on levelling strategy selected, see [[ZProbe]] ​ | <​kbd>​G29</​kbd>​ | | G29 | Probes the bed and outputs the bed heights depending on levelling strategy selected, see [[ZProbe]] ​ | <​kbd>​G29</​kbd>​ |
Line 108: Line 108:
 | M374 | Z grid strategy: save calibration grid.  optional S parameter saves a custom file with numerical extention | <​kbd>​M374 S123</​kbd>​ | | M374 | Z grid strategy: save calibration grid.  optional S parameter saves a custom file with numerical extention | <​kbd>​M374 S123</​kbd>​ |
 | M375 | Z grid strategy: load calibration grid.  optional S Parameter loads a pre saved custom grid  | <​kbd>​M375 S123</​kbd>​ | | M375 | Z grid strategy: load calibration grid.  optional S Parameter loads a pre saved custom grid  | <​kbd>​M375 S123</​kbd>​ |
 +| M375.1 | display the current grid   | <​kbd>​M375.1</​kbd>​ |
 | M400 | Wait for the queue to be empty before answering "​OK"​ | <​kbd>​M400</​kbd>​ | | M400 | Wait for the queue to be empty before answering "​OK"​ | <​kbd>​M400</​kbd>​ |
 | M407 | Get filament detector information | <​kbd>​M407</​kbd>​ | | M407 | Get filament detector information | <​kbd>​M407</​kbd>​ |