Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
rectangular-grid-calibration-options [2017/06/04 04:38]
wolfmanjm
rectangular-grid-calibration-options [2018/03/01 22:48]
195.218.22.174 Compensation dampening options added
Line 7: Line 7:
 || leveling-strategy.rectangular-grid.probe_offsets || 0,0,0  || Optional probe offsets from the nozzle or tool head in mm || || leveling-strategy.rectangular-grid.probe_offsets || 0,0,0  || Optional probe offsets from the nozzle or tool head in mm ||
 || leveling-strategy.rectangular-grid.save ​   || false   ​|| ​ If the saved grid is to be loaded on boot then this must be set to true || || leveling-strategy.rectangular-grid.save ​   || false   ​|| ​ If the saved grid is to be loaded on boot then this must be set to true ||
-|| leveling-strategy.rectangular-grid.initial_height || 10 || Optionally an initial_height (in mm) can be set that tell the initial probe where to stop the fast decent ​before it probes, this should be around 5-10mm above the bed ||+|| leveling-strategy.rectangular-grid.initial_height || 10 || The initial_height (in mm) tells the initial probe where to move to in Z before it probes, this should be around 5-10mm above the bed ||
 || leveling-strategy.rectangular-grid.human_readable ​   ||  true      || Human readable formatting of probe table || || leveling-strategy.rectangular-grid.human_readable ​   ||  true      || Human readable formatting of probe table ||
 || leveling-strategy.rectangular-grid.only_by_two_corners ||  true      || G29/31/32 will not work without providing XYAB parameters: ​       XY - start point, AB rectangle size from starting point. "Two corners""​ not absolutely correct name for this mode, because it use only one corner and rectangle size. This mode designed for PCB milling when you work with board size differ from bed size. More about this mode in [[/​pcb-milling|PCB milling]]|| || leveling-strategy.rectangular-grid.only_by_two_corners ||  true      || G29/31/32 will not work without providing XYAB parameters: ​       XY - start point, AB rectangle size from starting point. "Two corners""​ not absolutely correct name for this mode, because it use only one corner and rectangle size. This mode designed for PCB milling when you work with board size differ from bed size. More about this mode in [[/​pcb-milling|PCB milling]]||
 +|| leveling-strategy.rectangular-grid.dampening_start ||  NaN      || Compansation normally is applied for all heights, with full power. If you set this setting to a height, the compensation will start to be applied less and less (linearly) until "​height_limit"​ is reached. Any height before this setting is still will be compensated fully ||
 +|| leveling-strategy.rectangular-grid.height_limit ||  NaN      || The compensation algorithm will stop working after this limit, starting from the "​dampening_start"​ parameter. After the height goes through this limit, no more compansation will be applied ||