Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
panel [2018/02/12 15:03]
192.200.144.39 [Viki2 from panacutt.com]
panel [2019/03/06 17:58]
wolfmanjm old revision restored (2019/03/02 01:25)
Line 162: Line 162:
  
 On the back of the GLCD EXP1 is to left and EXP2 is to right, pin 1 is bottom left, pin 2 is top left etc. On the back of the GLCD EXP1 is to left and EXP2 is to right, pin 1 is bottom left, pin 2 is top left etc.
-=5v is EXP1 pin 10, Gnd is EXP1 pin 9+5v is EXP1 pin 10, Gnd is EXP1 pin 9
  
 <​code>​ <​code>​
Line 318: Line 318:
  
 <​code>​ <​code>​
-3.25<-- encoder ​ A  [2]-|¯¯¯¯¯|-[4] encoder sw -->GND+3.25<-- encoder ​ A  [2]-|¯¯¯¯¯|-[4] encoder sw -->GND
  ​GND<​-- encoder Com [1]-| (O) |  ​GND<​-- encoder Com [1]-| (O) |
 3.26<-- encoder ​ B  [3]-|_____|-[5] encoder sw -->1.30 3.26<-- encoder ​ B  [3]-|_____|-[5] encoder sw -->1.30
Line 362: Line 362:
 See the wiring diagram [[http://​chibidibidiwah.wdfiles.com/​local--files/​panel/​smoothieboard-LCD_1024.jpg|here]]. See the wiring diagram [[http://​chibidibidiwah.wdfiles.com/​local--files/​panel/​smoothieboard-LCD_1024.jpg|here]].
  
-Configuration : +Configuration :
  
 <​code>​ <​code>​
Line 387: Line 387:
 panel.external_sd.sdcd_pin ​         0.28!^ ​          # sd detect signal (set to nc if no sdcard detect) panel.external_sd.sdcd_pin ​         0.28!^ ​          # sd detect signal (set to nc if no sdcard detect)
 </​code>​ </​code>​
 +
 +