Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
multiple-extruders [2017/09/30 20:37]
arthur
multiple-extruders [2018/12/20 12:57] (current)
arthur
Line 99: Line 99:
 <callout type="​success"​ icon="​true"​ title="​1 hotend, two extruders">​ <callout type="​success"​ icon="​true"​ title="​1 hotend, two extruders">​
 If you have two extruders going into one hotend, you need to set-up two extruder modules, and one temperaturecontrol module. Make sure you name the temperaturecontrol differently from the extruder modules so none of them gets preference. If you have two extruders going into one hotend, you need to set-up two extruder modules, and one temperaturecontrol module. Make sure you name the temperaturecontrol differently from the extruder modules so none of them gets preference.
 +
 +If doing this setup with the Cura software, this additional Cura module might be helpful :​ https://​github.com/​pmarkiewicz/​CuraPostprocessingScripts
 </​callout>​ </​callout>​
 +
 +
  
 ==== Wiring ==== Wiring