Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
motion-control [2020/04/09 16:28]
wolfmanjm [Adjusting Z once printing starts (sometimes called babysteps)]
motion-control [2020/07/12 11:43] (current)
arthur [Adjusting Z once printing starts (sometimes called babysteps)]
Line 143: Line 143:
 A better and easier way is in the very latest edge build. A better and easier way is in the very latest edge build.
 ''​G43.2 Z0.1''​ will raise the Z by 0.1mm by setting the Z tool offset and also queing a move by 0.1mm, this is not instant but will happen when the previous g codes have executed. It can be cancelled with G49. **NOTE** as this uses tool offsets a multi extruder setup executing a T0 or T1 will reset the offset to the default for that tool. ''​G43.2 Z0.1''​ will raise the Z by 0.1mm by setting the Z tool offset and also queing a move by 0.1mm, this is not instant but will happen when the previous g codes have executed. It can be cancelled with G49. **NOTE** as this uses tool offsets a multi extruder setup executing a T0 or T1 will reset the offset to the default for that tool.
 +
 +If you want to do baby steps from the panel menus, you can easily do this using the custom_menu ( see http://​smoothieware.org/​panel#​all-configuration-options ) feature of panels: ​
 +
 +<​code>​
 +custom_menu.babystepup.enable ​              ​true ​             #
 +custom_menu.babystepup.name ​                Baby step up      #
 +custom_menu.babystepup.command ​             G43.2 Z0.05       #
 +
 +custom_menu.babystepdown.enable ​            ​true ​             #
 +custom_menu.babystepdown.name ​              Baby step down    #
 +custom_menu.babystepdown.command ​           G43.2 Z-0.05 ​     #
 +</​code>​
 +
  
 == All options == All options