Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
motion-control [2020/04/05 22:27]
wolfmanjm
motion-control [2020/04/09 16:28] (current)
wolfmanjm [Adjusting Z once printing starts (sometimes called babysteps)]
Line 141: Line 141:
 2. G0 Znnn # this will move the Z after the last received g code to nnn, you will need to make sure that nnn is the actual z height you want right now (usually the Z it is currently at, as 0.1mm will be added to that due to step 1) 2. G0 Znnn # this will move the Z after the last received g code to nnn, you will need to make sure that nnn is the actual z height you want right now (usually the Z it is currently at, as 0.1mm will be added to that due to step 1)
  
-A better and easier way is in the very latest edge (no build yet).+A better and easier way is in the very latest edge build.
 ''​G43.2 Z0.1''​ will raise the Z by 0.1mm by setting the Z tool offset and also queing a move by 0.1mm, this is not instant but will happen when the previous g codes have executed. It can be cancelled with G49. **NOTE** as this uses tool offsets a multi extruder setup executing a T0 or T1 will reset the offset to the default for that tool. ''​G43.2 Z0.1''​ will raise the Z by 0.1mm by setting the Z tool offset and also queing a move by 0.1mm, this is not instant but will happen when the previous g codes have executed. It can be cancelled with G49. **NOTE** as this uses tool offsets a multi extruder setup executing a T0 or T1 will reset the offset to the default for that tool.