Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
m3 [2017/01/25 14:38]
arthur
m3 [2017/01/25 18:55] (current)
arthur
Line 7: Line 7:
 A spindle is a controlled motor that turns a tool ( endmill ) at a given speed to allow it to remove material from the workpiece. A spindle is a controlled motor that turns a tool ( endmill ) at a given speed to allow it to remove material from the workpiece.
  
-The M3 command must be accompanied by a {{S}} parameter which sets the speed of rotation.+The M3 command must be accompanied by a <kbd>S</​kbd> ​parameter which sets the speed of rotation.
  
-M3's evil twin is the [[[M5]]] command which turns the spindle off ( it is equivalent to {{M3 S0}} ).+M3's evil twin is the [[M5]] command which turns the spindle off ( it is equivalent to <kbd>M3 S0</​kbd> ​).
  
 === Format === Format
Line 15: Line 15:
 The command is used as such :  The command is used as such : 
  
-[[code]]+<code>
 M3 S1000 M3 S1000
-[[/code]]+</code>
  
 Which means : start the spindle and make it turn at 1000 rotations per minute. Which means : start the spindle and make it turn at 1000 rotations per minute.
Line 24: Line 24:
  
 ||~ Parameter ||~ Usage ||~ Example || ||~ Parameter ||~ Usage ||~ Example ||
-|| {{S}} || The spindle must turn at this speed in rotations per minute || M3 S1000 ||+|| <kbd>S</​kbd> ​|| The spindle must turn at this speed in rotations per minute || M3 S1000 ||
  
 === Configuration === Configuration
  
-The spindle functionality of Smoothie is configured via the [/​spindle-module Spindle] module+The spindle functionality of Smoothie is configured via the [[/​spindle-module|Spindle]] module
  
 === Further reading === Further reading
  
 These resources are used as references for Gcode :  These resources are used as references for Gcode : 
-* [http://​linuxcnc.org/​docs/​html/​gcode.html LinuxCNC Gcode list] +[[http://​linuxcnc.org/​docs/​html/​gcode.html|LinuxCNC Gcode list]
-* [http://​reprap.org/​wiki/​G-code Reprap Gcode list]+[[http://​reprap.org/​wiki/​G-code|Reprap Gcode list]]