Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
guide-endstops [2018/05/31 13:57]
liliako [Endstops]
guide-endstops [2019/05/06 11:34] (current)
195.184.180.134 [Powered endstops wiring] changed endstop M119 trigger/not triggered text
Line 110: Line 110:
 To know exactly what your endstop does, see it's documentation. To know exactly what your endstop does, see it's documentation.
  
-If once wired, your endstop reports the opposite of what it should via the <​kbd>​M119</​kbd>​ command ( <​kbd>​1</​kbd>​ when not triggered, and <​kbd>​0</​kbd>​ when triggered ), see the "​Testing"​ section.+If once wired, your endstop reports the opposite of what it should via the <​kbd>​M119</​kbd>​ command ( <​kbd>​1</​kbd>​ when triggered/pushed, and <​kbd>​0</​kbd>​ when not triggered ), see the "​Testing"​ section.
  
-Some endstops might require removing their "​pull-up"​ configuration,​ in this case, change : +Some endstops might require removing their "​pull-up"​ configuration,​ in this case, change :
  
 <​code>​ <​code>​
Line 130: Line 130:
 </​code>​ </​code>​
  
-In some very rare cases, the endstop reading circuit on the [[Smoothieboard]] will not be adequate for your endstop type. In this case, you should use a "​free" ​GPIO pin ​on the Smoothieboard that nothing else uses to connect your endstop to.+In some very rare cases, the endstop reading circuit on the [[Smoothieboard]] will not be adequate for your endstop type. In this case, you should use a "​free" ​GPIO pin ​on the Smoothieboard that nothing else uses to connect your endstop to.
  
 See [[Pinout]] to find adequate pins. See [[Pinout]] to find adequate pins.