Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
guide-endstops [2018/05/31 13:57]
liliako [Endstops]
guide-endstops [2018/05/31 14:16]
liliako [Powered endstops wiring]
Line 112: Line 112:
 If once wired, your endstop reports the opposite of what it should via the <​kbd>​M119</​kbd>​ command ( <​kbd>​1</​kbd>​ when not triggered, and <​kbd>​0</​kbd>​ when triggered ), see the "​Testing"​ section. If once wired, your endstop reports the opposite of what it should via the <​kbd>​M119</​kbd>​ command ( <​kbd>​1</​kbd>​ when not triggered, and <​kbd>​0</​kbd>​ when triggered ), see the "​Testing"​ section.
  
-Some endstops might require removing their "​pull-up"​ configuration,​ in this case, change : +Some endstops might require removing their "​pull-up"​ configuration,​ in this case, change :
  
 <​code>​ <​code>​
Line 130: Line 130:
 </​code>​ </​code>​
  
-In some very rare cases, the endstop reading circuit on the [[Smoothieboard]] will not be adequate for your endstop type. In this case, you should use a "​free" ​GPIO pin ​on the Smoothieboard that nothing else uses to connect your endstop to.+In some very rare cases, the endstop reading circuit on the [[Smoothieboard]] will not be adequate for your endstop type. In this case, you should use a "​free" ​GPIO pin ​on the Smoothieboard that nothing else uses to connect your endstop to.
  
 See [[Pinout]] to find adequate pins. See [[Pinout]] to find adequate pins.