Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
g4 [2017/01/25 16:09]
arthur
g4 [2017/01/25 18:55] (current)
arthur
Line 1: Line 1:
-[[[f>​image https://​upload.wikimedia.org/​wikipedia/​commons/​thumb/​a/​ac/​Waiting_room_icon.svg/​2000px-Waiting_room_icon.svg.png style="​width:​400px"​]]]+[[f>​image https://​upload.wikimedia.org/​wikipedia/​commons/​thumb/​a/​ac/​Waiting_room_icon.svg/​2000px-Waiting_room_icon.svg.png style="​width:​400px"​]]
  
 == G4 G-code == G4 G-code
Line 9: Line 9:
 The command is used as such :  The command is used as such : 
  
-[[[code]]]+<code>
 G4 S5 G4 S5
-[[[/code]]]+</code>
  
 Which means : pause for 5 seconds. Which means : pause for 5 seconds.
Line 20: Line 20:
  
 ||~ Parameter ||~ Usage ||~ Example || ||~ Parameter ||~ Usage ||~ Example ||
-|| {{S}} || Duration to wait in seconds || G4 S10 || +|| <kbd>S</​kbd> ​|| Duration to wait in seconds || G4 S10 || 
-|| {{P}} || Duration to wait in milliseconds ( thousandth of a second ) || G4 P100 ||+|| <kbd>P</​kbd> ​|| Duration to wait in milliseconds ( thousandth of a second ) || G4 P100 ||
  
-Note that if {{grbl_mode}} is set to {{true}} then the {{P}} parameter is the duration to wait in seconds, not milliseconds,​ as a float value. This is to conform to G-Code standards.+Note that if <kbd>grbl_mode</​kbd> ​is set to <kbd>true</​kbd> ​then the <kbd>P</​kbd> ​parameter is the duration to wait in seconds, not milliseconds,​ as a float value. This is to conform to G-Code standards.
  
 === Further reading === Further reading
  
 These resources are used as references for Gcode :  These resources are used as references for Gcode : 
-* [[http://​linuxcnc.org/​docs/​html/​gcode.html LinuxCNC Gcode list]] +* [[http://​linuxcnc.org/​docs/​html/​gcode.html|LinuxCNC Gcode list]] 
-* [[http://​reprap.org/​wiki/​G-code Reprap Gcode list]]+* [[http://​reprap.org/​wiki/​G-code|Reprap Gcode list]]