Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
g28-cnc [2017/01/25 16:21]
arthur
g28-cnc [2017/01/25 18:55] (current)
arthur
Line 15: Line 15:
 The command is used as such :  The command is used as such : 
  
-[[code]]+<code>
 G28 G28
-[[/code]]+</code>
  
 Which means : to the origin position. Which means : to the origin position.
Line 37: Line 37:
 === Speeds === Speeds
  
-The speed at which the movement to the origin point will occur is the "​seek"​ speed, which is the speed of the last [[G0]] command issued, or if none was ever issued, the value of the {{default_seek_rate}} configuration [[/​configuring-smoothie|option]].+The speed at which the movement to the origin point will occur is the "​seek"​ speed, which is the speed of the last [[G0]] command issued, or if none was ever issued, the value of the <kbd>default_seek_rate</​kbd> ​configuration [[/​configuring-smoothie|option]].
  
 === Endstop seeking === Endstop seeking
  
-If you are looking for a way to "​home"​ to the endstops, the same way {{G28}} does on 3D printers, use the {{$H}} command to trigger this behavior, and configure it using the [[Endstop]] module.+If you are looking for a way to "​home"​ to the endstops, the same way <kbd>G28</​kbd> ​does on 3D printers, use the <kbd>$H</​kbd> ​command to trigger this behavior, and configure it using the [[Endstop]] module.
  
 === Further reading === Further reading