Hi All, I have a Ultibots MK delta kit that came with a RAMPS board, but I wanted to try a 32bit board as it was said to overcome some of the ridging artifacts that deltas get with Arduino based systems. I have the settings for Marlin for the printer, and am trying to adapt them for the smoothieware delta config to run on a Azteeg x5 board.
Mostly, I think I have a handle on it, arm length and radius being the big ones, MM/sec converted to MM/Min. Some settings I am not sure about either what exactly they do, or what they should be set to, so if there is any insight people here have to offer I would greatly Appreciate it.
delta_segments_per_second is default 100, I had it set in Marlin to 200, should I set it to 200?
junction_deviation 0.05 in Marlin - #define DEFAULT_XYJERK 2.0; this seems much much higher so what would the equivalent be?
Stepper Motor currents, what is a good baseline for a Kysan NEMA 17 Stepper Motor? is this a setting that needs to be calibrated?
Also, the thermosister for the heated bed I have is I believe 100K QWG-104F-3950, but on github, I couldnt find a list of compatible thermosisters in src/modules/tools/temperaturecontrol/TemperatureControl.cpp:64.
Any advice would be appreciated. thanks