Last night I was working on setting up a mini 5v servo for a z probe and all was going good. That was until it just randomly stopped working and I noticed that led for Q6 was dimly lit. Shut everything down reset everything and now I can't get power to Q6. It's for my heated bed and I can see the lcd says it's on but no power or led. But I do still get a dim led for Q6 whenever I power on the servo. For the servo I have sig p2.5 power from z max and ground to the one just near to p2.5.
Should I have ran the servo from external power?
…… Just noticed that pin 2.5 was also assigned to that mosfet.. Stupid me. Did I damage anything or is this just a conflict in the config?