I've been using a smoothieboard 5X to run a 3 axis CNC and so far have been very impressed.
Today while running a test of some gcode, the job stopped mid run. On investigation using prontface the board is working fine until I move the X, when I get the following reported back Print paused at: I get this using the prontface buttons, sending gcode including a x move also makes the smootie unresponsive. Once I have had this response then all other instructions are ignored and I have to power off and then power back on to get any response.
I suspect my wiring on the X so will be rewiring the stepper (nema 17). A visual inspection of the smoothie shows no obvious signs of damage.
Is it possible to remap via the config to get the x controlled from x4 or x5?