I cannot find out why my "home all" command moves just 10mm at a time and does not go all the way to the endstops. Could someone suggest possible places I might look in the config for conflicts? It is a Smoothieboard for a delta. Everything else works, but I can't print if I can't get home to configure. No probe, manual configuration. TIA
Summary:"Home all" moves only 10 mm at a time.
Can't properly home
1d1 10 Sep 2015 22:18
Re: Can't properly home
arthurwolf 10 Sep 2015 22:20
This sounds very much like your endstops are not properly wired, or inverted.
What does M119 report when the endstops are triggered, and what does it report when they are not triggered ?