I am using OctoPrint hosted on a Raspberry Pi 2
Slice model up in Cura, upload to OctoPrint, click print. Bed heats up, nozzle heats up then it starts the auto levelling procedure through the G32 command. It completed the procedure and all is well, then LED 2 goes out and the printer stops responding. I have to reset the board using the reset button.
The Config file for the auto levelling is as below:
gamma_min_endstop nc # gamma_max_endstop nc # zprobe.enable true # set to true to enable a zprobe zprobe.probe_pin 1.28! # pin probe is attached to if NC remove the ! zprobe.slow_feedrate 5 # mm/sec probe feed rate #zprobe.debounce_count 100 # set if noisy zprobe.fast_feedrate 100 # move feedrate mm/sec zprobe.probe_height 5 # how much above bed to start probe # associated with zprobe the leveling strategy to use leveling-strategy.three-point-leveling.enable true # a leveling strategy that probes three points to define a plane and keeps the Z parallel to that plane leveling-strategy.three-point-leveling.point1 100.0,0.0 # the first probe point (x,y) optional may be defined with M557 leveling-strategy.three-point-leveling.point2 100.0,100.0 # the second probe point (x,y) leveling-strategy.three-point-leveling.point3 100,200.0 # the third probe point (x,y) leveling-strategy.three-point-leveling.home_first true # home the XY axis before probing leveling-strategy.three-point-leveling.tolerance 0.03 # the probe tolerance in mm, anything less that this will be ignored, default is 0.03mm leveling-strategy.three-point-leveling.probe_offsets 41.5,0,0 # the probe offsets from nozzle, must be x,y,z, default is no offset leveling-strategy.three-point-leveling.save_plane false # set to true to allow the bed plane to be saved with M500 default is false
The gcode at the start of the file is:
M190 S70.000000 ;Sliced at: Tue 30-06-2015 13:18:34 ;Basic settings: Layer height: 0.5 Walls: 0.8 Fill: 0 ;Print time: 1 hour 43 minutes ;Filament used: 20.592m 61.0g ;Filament cost: None M109 T0 S245 G21 ;metric values G90 ;absolute positioning M82 ;set extruder to absolute mode M107 ;start with the fan off G32 G90 G1 F3000 ;Layer count: 260 ;LAYER:0 M106 S76 G0 F3000 X44.500 Y44.500 Z0.500
And that G0 is the last line that gets sent to the Printer before it crashes. Any ideas?