I've just swap my mega+ramps to a smoothieboard compatible (azsmz) on my delta.
But when i try to print the smoothie board pause every 5 min for about 10 min then continue the job ( even the pannel is not responsible).
I try to put a new usb cable with ferrite at each end as i read here but it didn't help.
It append even with print from SD card, it append also with the G32 calibration.
What can it be ?
azsmz board + azsmz panel
Windows 8.1 (i've try 1.0 and 1.1 drivers)
latest edge firmware