So I noticed that when I first start my printer up and run my extruder it goes unreasonably fast. I looked in the config file and here are the settings for the extruder:
- Extruder module configuration
extruder_module_enable true # Whether to activate the extruder module at all. All configuration is ignored if false
extruder_steps_per_mm 174.87 # Steps per mm for extruder stepper
extruder_default_feed_rate 400 # Default rate ( mm/minute ) for moves where only the extruder moves
extruder_acceleration 3000 # Acceleration in mm/sec^2 only used for retracts
extruder_max_speed 100 # mm/sec NOTE only used for retracts
I have tried changing the numbers for default feed rate and max speed but it doesn't seem to make any difference when I try running the extruder. Has anyone else had a similar problem? and any suggestions for things to try?