Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
filament-detector [2018/05/30 11:27]
90.60.22.246 [Filament detector]
filament-detector [2019/06/23 19:12] (current)
90.155.91.76 [Configuration options] Fixed table layout (headings were previously misaligned)
Line 21: Line 21:
  
 ^ Option ^ Example value ^ Explanation ^ ^ Option ^ Example value ^ Explanation ^
-|| filament_detector.enable ​|| true || This module is activated only if this is set to <​kbd>​true</​kbd> ​|+| filament_detector.enable | true | This module is activated only if this is set to <​kbd>​true</​kbd>​ | 
-|| filament_detector.encoder_pin ​|| 2.11 || This is the pin the encoder is connected to. Must be an interrupt pin |+| filament_detector.encoder_pin | 2.11 | This is the pin the encoder is connected to. Must be an interrupt pin | 
-|| filament_detector.bulge_pin ​|| 1.31 || OPTIONAL This is the pin the bulge switch is connected to. If this switch is triggered ( by a bulge in the filament ) and the filament is moving, this will trigger an alarm |+| filament_detector.bulge_pin | 1.31 | OPTIONAL This is the pin the bulge switch is connected to. If this switch is triggered ( by a bulge in the filament ) and the filament is moving, this will trigger an alarm | 
-|| filament_detector.seconds_per_check ​|| 2 || How many seconds between filament position checks, must be long enough for several pulses to be detected, but not too long |+| filament_detector.seconds_per_check | 2 | How many seconds between filament position checks, must be long enough for several pulses to be detected, but not too long | 
-|| filament_detector.pulses_per_mm ​|| 0.5 || The number of pulses the encoder produces for every millimeter of filament movement ​||+| filament_detector.pulses_per_mm | 0.5 | The number of pulses the encoder produces for every millimeter of filament movement |
  
 == Hardware == Hardware