Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
filament-detector [2018/03/05 15:45]
93.36.188.172 [Filament detector]
filament-detector [2018/05/30 11:27] (current)
90.60.22.246 [Filament detector]
Line 8: Line 8:
  
 If a difference is detected, the filament is not advancing correctly, which means that there is a problem with the pushing of the filament. If a difference is detected, the filament is not advancing correctly, which means that there is a problem with the pushing of the filament.
 +
 +Use **M404** command to set filament detector parameters: S seconds per check, P pulses per mm
 +
 +Use **M405** command to disable filament detector
 +Use **M406** command to enable filament detector
  
 Use **M407** command to check if the filament detector gets triggered Use **M407** command to check if the filament detector gets triggered
 +
 +
 +
 == Configuration options == Configuration options