Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
filament-detector [2018/05/30 11:25]
90.60.22.246 [Filament detector]
filament-detector [2019/06/23 19:12]
90.155.91.76 [Configuration options] Fixed table layout (headings were previously misaligned)
Line 9: Line 9:
 If a difference is detected, the filament is not advancing correctly, which means that there is a problem with the pushing of the filament. If a difference is detected, the filament is not advancing correctly, which means that there is a problem with the pushing of the filament.
  
-Use **M407** command to check if the filament detector ​gets triggered+Use **M404** command to set filament detector ​parameters: S seconds per check, P pulses per mm
  
 Use **M405** command to disable filament detector Use **M405** command to disable filament detector
 Use **M406** command to enable filament detector Use **M406** command to enable filament detector
  
-Use **M406** command to set filament detector ​parameters: S seconds per check, P pulses per mm+Use **M407** command to check if the filament detector ​gets triggered 
 + 
 + 
 == Configuration options == Configuration options
  
 ^ Option ^ Example value ^ Explanation ^ ^ Option ^ Example value ^ Explanation ^
-|| filament_detector.enable ​|| true || This module is activated only if this is set to <​kbd>​true</​kbd> ​|+| filament_detector.enable | true | This module is activated only if this is set to <​kbd>​true</​kbd>​ | 
-|| filament_detector.encoder_pin ​|| 2.11 || This is the pin the encoder is connected to. Must be an interrupt pin |+| filament_detector.encoder_pin | 2.11 | This is the pin the encoder is connected to. Must be an interrupt pin | 
-|| filament_detector.bulge_pin ​|| 1.31 || OPTIONAL This is the pin the bulge switch is connected to. If this switch is triggered ( by a bulge in the filament ) and the filament is moving, this will trigger an alarm |+| filament_detector.bulge_pin | 1.31 | OPTIONAL This is the pin the bulge switch is connected to. If this switch is triggered ( by a bulge in the filament ) and the filament is moving, this will trigger an alarm | 
-|| filament_detector.seconds_per_check ​|| 2 || How many seconds between filament position checks, must be long enough for several pulses to be detected, but not too long |+| filament_detector.seconds_per_check | 2 | How many seconds between filament position checks, must be long enough for several pulses to be detected, but not too long | 
-|| filament_detector.pulses_per_mm ​|| 0.5 || The number of pulses the encoder produces for every millimeter of filament movement ​||+| filament_detector.pulses_per_mm | 0.5 | The number of pulses the encoder produces for every millimeter of filament movement |
  
 == Hardware == Hardware