Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
extruder [2018/02/01 16:01]
146.90.249.33 [G-code]
extruder [2020/05/11 23:26] (current)
arthur [G-code]
Line 30: Line 30:
 * <​kbd>​M82</​kbd>​ : Set absolute mode for extruder only * <​kbd>​M82</​kbd>​ : Set absolute mode for extruder only
 * <​kbd>​M83</​kbd>​ : Set relative mode for extruder only * <​kbd>​M83</​kbd>​ : Set relative mode for extruder only
-* <​kbd>​M84</​kbd>​ :​ Turn ​the active ​stepper motor driver'​s on+* <​kbd>​M84</​kbd>​ :​ Turn ​off stepper motor drivers
 * <​kbd>​M92</​kbd>​ : Set this axis' steps per millimetre. For example <​kbd>​M92 E100</​kbd>​ to set for the currently active Extruder, or <​kbd>​T1 M92 E100</​kbd>​ to set for the second extruder. * <​kbd>​M92</​kbd>​ : Set this axis' steps per millimetre. For example <​kbd>​M92 E100</​kbd>​ to set for the currently active Extruder, or <​kbd>​T1 M92 E100</​kbd>​ to set for the second extruder.
 * <​kbd>​M114</​kbd>​ : Displays XYZ position, as well as the E position of the currently active Extruder * <​kbd>​M114</​kbd>​ : Displays XYZ position, as well as the E position of the currently active Extruder