Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
extruder-guide [2018/06/25 13:21]
143.159.81.111 [Extruder]
extruder-guide [2018/06/25 13:37] (current)
143.159.81.111 [Extruder]
Line 16: Line 16:
 The most important parameter to get your extruder module to work properly, is <​kbd>​extruder.[[module-name]].**steps_per_mm**</​kbd>​. The most important parameter to get your extruder module to work properly, is <​kbd>​extruder.[[module-name]].**steps_per_mm**</​kbd>​.
  
-You can create as many Extruder modules as you want (although you may run out of memory and smoothie will no longer boot), as long as you give them different module names. You can name those modules whatever you want ( as long as you stick to only alphanumerical characters ).+You can create as many Extruder modules as you want (although you may run out of memory and smoothie will no longer boot), as long as you give them different module names. You can name those modules whatever you want ( as long as you stick to only alphanumerical characters ). **NOTE** that the default build of Smoothie only supports 2 extruders (5 axis), if you need 3 extruders you need to compile with  ''​make AXIS=6''​
  
 === Configuration === Configuration