Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
endstops [2018/07/05 14:49]
80.114.104.249 [Soft endstops]
endstops [2018/09/10 13:46] (current)
51.6.19.46
Line 94: Line 94:
  
 Endstops may be configured to act as limit switches, during normal operations if any enabled limit switch is triggered the system will halt and all operations will stop, it will send a !! command to the host to stop it sending any more data (a recent dev octoprint and recent [[Pronterface]] support this). Endstops may be configured to act as limit switches, during normal operations if any enabled limit switch is triggered the system will halt and all operations will stop, it will send a !! command to the host to stop it sending any more data (a recent dev octoprint and recent [[Pronterface]] support this).
-reset will be required to continue, or sending M999, make sure you move away from the endstop though before trying to move.+Sending $X, or sending M999, or a reset will be required to continue. Make sure you move away from the endstop though before trying to move.
  
 To enable enstops as limit switches the following config options can be used, they are disabled by default. To enable enstops as limit switches the following config options can be used, they are disabled by default.
Line 197: Line 197:
 </​callout>​ </​callout>​
  
-== External ​ressources+== External ​resources
  
 === General video about mechanical endstops === General video about mechanical endstops