Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
endstops-options [2017/01/25 18:35]
arthur
endstops-options [2017/05/23 08:20] (current)
wolfmanjm
Line 7: Line 7:
 || alpha_max_endstop || <​kbd>​1.25^</​kbd>​ || Alpha ( X axis or alpha tower ) maximum limit endstop. Set to <​kbd>​nc</​kbd>​ if not installed on your machine. ||  || alpha_max_endstop || <​kbd>​1.25^</​kbd>​ || Alpha ( X axis or alpha tower ) maximum limit endstop. Set to <​kbd>​nc</​kbd>​ if not installed on your machine. || 
 || alpha_homing_direction || home_to_min || In which direction to home. If set to <​kbd>​home_to_min</​kbd>,​ homing ( using the <​kbd>​G28</​kbd>​ G-code ) will move until it hits the minimum endstop and then set the current position to <​kbd>​alpha_min</​kbd>​. If set to <​kbd>​home_to_max</​kbd>,​ homing will move until it hits the maximum endstop, and then set the current position to <​kbd>​alpha_max</​kbd>​ ||  || alpha_homing_direction || home_to_min || In which direction to home. If set to <​kbd>​home_to_min</​kbd>,​ homing ( using the <​kbd>​G28</​kbd>​ G-code ) will move until it hits the minimum endstop and then set the current position to <​kbd>​alpha_min</​kbd>​. If set to <​kbd>​home_to_max</​kbd>,​ homing will move until it hits the maximum endstop, and then set the current position to <​kbd>​alpha_max</​kbd>​ || 
-|| alpha_min || 0 || This gets loaded after homing when alpha_homing_direction is set to <​kbd>​home_to_min</​kbd>​ and the minimum endstop is hit. || +|| alpha_min || 0 || This gets loaded after homing when alpha_homing_direction is set to <​kbd>​home_to_min</​kbd>​ and the minimum endstop is hit. **NOTE** the homing offset is added to this set with M206 Xnnn || 
 || alpha_max || 200 || This gets loaded after homing when alpha_homing_direction is set to <​kbd>​home_to_max</​kbd>​ and the maximum endstop is hit. ||  || alpha_max || 200 || This gets loaded after homing when alpha_homing_direction is set to <​kbd>​home_to_max</​kbd>​ and the maximum endstop is hit. || 
 || alpha_max_travel || 500 || This determines how far the X axis can travel looking for the endstop before it gives up ||  || alpha_max_travel || 500 || This determines how far the X axis can travel looking for the endstop before it gives up ||