Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
drillingcycles [2017/01/25 23:45]
arthur
drillingcycles [2017/04/21 18:05] (current)
67.140.70.105 Just spelling correction
Line 1: Line 1:
 = Drilling cycles module = Drilling cycles module
 Basically the canned drilling cycles is a short G-Code produced by some serious CAM software to make holes. Basically the canned drilling cycles is a short G-Code produced by some serious CAM software to make holes.
-In addition to adding some features this significantly reduces the number of instructions ​send through the serial port.+In addition to adding some features this significantly reduces the number of instructions ​sent through the serial port.
  
 Currently the drilling cycles module implement the first three options in absolute mode <​kbd>​G90</​kbd>​ only. Currently the drilling cycles module implement the first three options in absolute mode <​kbd>​G90</​kbd>​ only.